Processing of rigid & flexible polyurethane foam materials

vmt 2000

Request free advice

N.B. Fields marked with an asterisk (*) are compulsory.

Company* Address* E-Mail*

Which machine/s would you like to receive information about?

Model* Would you like to receive a hard copy of the catalogue? (YES - NO)* Would you like to receive a free quote? (YES - NO)*

! Privacy policy !

YES: I hereby give my consent NO: I refuse to give my consent

Send/delete data entered

position of the page: home / Vertical cutting machines ► vmt 2000

Technical characteristics

[Pictures are purely demonstrative. Machines are subject to change due to technological innovations or adjustments to regulations]

The cutting head runs on large-size hardened and ground steeel slideway packs to eliminate all risk of wear
The control panel is with incremental Joystick (where the lever stroke chainges the cutting speed) controlling movement of the cutting head
Advance of the gauge panel is controlled via a millimetre graduated mechanical device for repetitive cutting of sheets up to a maximun of 140 mm.
Adjustable disc brake on the operator side
Electrical equipment in metal box with low voltage controls
Knife present detector sensor which stops the machine if the knife breaks
Motor-driven knife regrinder
Head run = cm. 230
Width of the sliding carriage from the square support to the blade = cm. 220
Width of the sliding carriage from the blade to the outer platform = cm. 125
Usable height for cut = cm. 130
Height square= cm. 110
Consumption at 380 Volt 50 Hz = 4 KW.