Video: vm 2000 - vm 1400

Get the Flash Player to see this player.
position of the page: home / Vertical cutting machines ► vm 2000 standard - vm 1400 small

Technical characteristics

[Pictures are purely demonstrative. Machines are subject to change due to technological innovations or adjustments to regulations]

  • VM 1400
    • Length of the sliding carriage = cm. 240
    • Width of the sliding carriage from the square support to the blade = cm. 140
    • Width of the sliding carriage from the blade to the outer platform = cm. 125
    • Max block height = cm. 130
    • Square height = cm. 110
  • VM 2000
    • Length of the sliding carriage = cm. 240
    • Width of the sliding carriage from the square support to the blade = cm. 220
    • Width of the sliding carriage from the blade to the outer platform = cm. 125
    • Max block height = cm. 130
    • Square height = cm. 110
  • Power supply 380 Volt 50 Hz
  • Energy used 3 KW
  • Mechanical device for repetitive cuts of polyurethane sheets
  • Blade sharpener run by engines for cutting in both directions
  • Possibility to incline the square more than 45°
  • Electrical control panel with separate push-button commands on sliding carriage
  • On request: motorization of blade’s protective staff.